Your water heater is one of the used and more expensive appliances in your home, and consumes a large associated with your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving from the home heating and costs.
Regular flushing of one’s water heater is considered the single most important step you can take to prolong its service life this particular save energy. During time, sediments mount up in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. Partly destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most areas of the country, the standard water heater lasts 3-5 years. Regularly flushing your water heater can double existence of your water heater from 3-5 to 7-10 years. Device costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater is critical in today’s weather. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of hot water your home uses, that can mean a savings of $20 to over $50 a week.
To drain your water heater, initially you should set the thermostat to pilot (if it can be a gas water heater) or turn the circuit breaker off (if it is definitely an electric heater). Failure to do so could result in overheating and severe damage to water heater. Next, close the water supply valve located in the water inlet line going into your water heater. You may then connect a hose to the drain valve located in the bottoom of the central heater. Open the drain and allow it to move until all for the water has emptied from the hot water heater. Then close the drain. Open the water supply valve and refill the hot water heater. You should also open a hot water faucet somewhere inside and stand there and watch it run for several minutes until the actual flows out perfectly. This will allow air to vent because of the heater and the hot water lines. Finally, you can turn the thermostat back to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system home to filter or condition the water so is certainly less corrosive to your plumbing system, particularly in areas which have hard wetness. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in your area to discuss options and merchandise to suit your needs.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX
(281) 528-1610